Antique Cars in Miniatures

Production of a wheel of management. For production of a wheel I used the telescopic antenna from the radio receiver. A core as a wheel and tubes for production of holders of a wheel. I have made the top part of a wheel on hinged connection.


The top holder I has inserted in has spent on drink a piece of a tube and has bent inside.


I have turned the handle from a tree and I have inserted into the drilled wheel opening.


The lower holder has made of a strip of brass which he has bent and has soldered to a tube. After that I cut off the necessary length of a tube and ink. In the lower part of a wheel I have soldered the lever of draft and too I blackened.

Wheel assembled.

Well and actually installation of a wheel. At first on glue the top holder, has assigned to that lower. I have fixed everything by carnations.

Behind that I have made draft of a brass bar and I have fixed it on a forward axis. After that I have pasted a forward axis to springs and I have fixed the second part of the lever with the wheel lever. Generally the wheel is ready.

Now I do a back axis. I have ground a reducer detail, too have corrected brake disks.

In a reducer I have drilled holes for imitation of an exit of a chain. Behind that having measured length, I cut off a string-chain and I have pasted in a reducer.

I have pasted brake disks, but the reducer left not pasted.

After that I glued details in the following sequence – at first an axis to springs, then after fitting a reducer and the last the electric motor.

I pass to production of a forward axis. Except the axis from a set the brass tube, a leaf and a wire will be necessary for me. Process of production is visible in photos. After production I do everything black.








Well and fitting of everything that I have made at the moment. And on model too.